figured it out with the help of a co-worker!! the wires have a coating on them so the current was not flowing!!
now my question is..
I have 2 other wires/ pins that are from the back of the s-mode button, 1 is for ground and the other is for illumination...
do I need to connect the ground? I do plan to tap the illumination into the hazard light sw...or would there be another place where I can top the illumination from?
Also is the ground required for this switch? would it be better to have? since the kenwood switch did not have it?
Also is there a non -trail -n error approach to figure out which one is ground and which is illumination?
Thanks,
Jay
__________________
-Jay
|