Nissan 370Z Forum - View Single Post

gotchu99 · 06-02-2011, 07:56 PM

Was wondering if anyone has had any problems with the Berk CBE tips sticking out to far past the rear bumper. I had a local shop do the install and noticed that the tips were not flush (actually 2 inches past the bumper). I figured I would just adjust them when I got home. Well I loosened them up and removed the tips, but no matter how much pressure I put on the tips they wont go any further into the pipe. I even grabbed a board so I can use a hammer to get them to go in further, no luck. Seems like there is a little seam on the inside of the exhaust tip and that may be hanging the pipe up? The reason I bought Berk was for the stock look. This looks bad sticking out so far. Thanks in advance for any advice. I will go back tomorrow to the shop that did the install and see if they can adjust them.

06-02-2011, 07:56 PM	#1 (permalink)
gotchu99 Base Member Join Date: Feb 2011 Location: ny Posts: 86 Drives: '09 370z black mt, Rep Power: 14	Berk CBE Help Was wondering if anyone has had any problems with the Berk CBE tips sticking out to far past the rear bumper. I had a local shop do the install and noticed that the tips were not flush (actually 2 inches past the bumper). I figured I would just adjust them when I got home. Well I loosened them up and removed the tips, but no matter how much pressure I put on the tips they wont go any further into the pipe. I even grabbed a board so I can use a hammer to get them to go in further, no luck. Seems like there is a little seam on the inside of the exhaust tip and that may be hanging the pipe up? The reason I bought Berk was for the stock look. This looks bad sticking out so far. Thanks in advance for any advice. I will go back tomorrow to the shop that did the install and see if they can adjust them.