jayl

1. Do I need to use a roller for applying dynamat?

2. Do I need to use a heat gun for applying dynamat?

3. To be sure, any wires that I run should go over the dynamat right?

I am thinking the correct way to install dynamat after the surface is clean...

- stick dynamat then use a roller / heat gun to get it to stick on the trunk fully
- remove air pockets

Please let me know if there is something I am missing... also if there is a way to do the install without the use of a roller or heat gun please advise..

I do not have a place where i can plug in a heat gun near the car.. I was thinking of using an inverter.. Also instead of the roller I am thinking of using a rubber maillot.

Thanks,