A Porter Cable is just fine. For people with less experience it's the best choice. I still use it most of the time by the way. Always do the least abrasive method for paint correction, so start with a fine polish and polishing pad and move up from there.
Opti-Coat is based on a resin pre-polymer and once it is applied, it cross links and reacts with urethane and other clear coat paints to form a permanent film. Opti-Coat has better chemical resistance, scratch & mar resistance, and release properties than any automotive coating in use. Like a regular clear coat, Opti Coat lasts indefinitely unless it is removed by polishing, sanding, or paint removers.
DIRECTIONS
1. Remove defects to your satisfaction
2. Clean surface to remove all polishing oils, waxes, and silicone.
3. Prime the applicator by making an X across the pad. Only a few drops will be needed for each subsequent panel.
4. Wipe Opti-Coat on a single panel at a time in a thin layer using several directions for even coverage.
5. Inspect the panel with adequate lighting withing 5-10 minutes looking for any thick areas that have not flashed away to clear.
6. Use applicator or paint safe microfiber to even out (no pressure)any spots where you see streaks. This step is key, as any spots not leveled will have to be abrasively repaired is allowed to cure. Panels will feel a bit tacky and will be self -leveling during cure time, so avoid any unnecessary touching, wiping, or contact to produce the best results.
7. Repeat steps 1-6 for each panel where application is desired.
NOTE: Take care to get complete coverage in your initial application as Opti Coat CANNOT be layered.
Quote:
Originally Posted by KravMaga
I take it u just strip it off with rubbing alcohol? I have a porter cable. Do I need something more qgressive like the flex or a rotary? Got any pics or write up of application? Thanks for the info!
|